Make sure the vehicle is at a complete stop. Turn the engine switch off. Adjust the tire inflation pressure recommended on the tire placard located on the door panel. Turn the engine switch to the “ON” position. Use the information display controls on the steering wheel and highlight Setting Menu. Press the OK button to choose it.
Place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor. Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire. A chirp horn will confirm that the sensor has been reset. Turn off the ignition after you reset the last tire.
During winter season, 2016 Ford F-250 Super Duty tires can be inflated 3 to 5 psi over the suggested tire pressure settings to make up for lower temperatures. Never over-inflate above psi showed on tire sidewall. Try to check tire pressure routinely in colder times to keep tires appropriately inflated for a safe ride on snow and frosty streets.
For push-button ignitions, press the START/STOP button once while not touching either of the pedals. Within a 10-second window, turn your Ford’s hazards lights on and then off three times. If you do it correctly, the horn will sound. Activate the TPMS sensor by removing the valve cap on the tire.
The following tire pressure reset procedure applies to the Ford F150 12th generation (2009–2014) and 13th generation (2015–present). To Reset the Ford F150 Tire Pressure System: Drive for at least two minutes and at a speed of 20 mph (32 km/h) or more, then safely park you vehicle where you have access to an air pump.
Select the Vehicle Information Menu by using the MENU button on the turn signal lever. . Scroll down and select Tyre Pressure menu. . Press SET/CLR button to reset TPMS. . Press the SET/CLR button again to confirm the selection. If the reset mode has been entered successfully, the horn will sound once. .
ccfanx. 203 415 306 113 210 211 281 230 65
ford c max 2016 tyre pressure reset
