While the engine is warm, set the parking brake and put the transmission in neutral. After that, open the cover plate on the tank compartment and locate the SCR cleaning operation switch. Move the switch to the left to start the refresh process. From there the process will occur automatically, taking approximately 35 minutes.
How long should a DPF Regen take? The DPF regeneration cycle takes approximately an hour and a half (1 1/2 hours) to complete and can be completed as part of a routine service. How long does a regen usually last? The process should last between 45 minutes to an hour and no longer. If your parked regen takes longer than this or isn't finishing
It's doing what it is supposed to do. Passive regens are normally happening a couple times a day. If one finishes, and then an hour later it has to do another, then there is a problem. If you get asked to perform a parked regen, then the system cannot keep up. You cannot start a parked regen if the system is not asking for one.
Once hot, stationary regeneration @ 2,200 rpm requires a consistent 16 minutes to complete. Next stationary regeneration, experiment with higher engine rpms. Stationary regeneration fuel cost is only ~~$1.00 Does RK55 manual suggest engine rpms during stationary regeneration?
The B3350 has had the lion's share of regen problems, that those of us with different models have not had so far, and if your dealer does not fix it, you might think about invoking the lemon law and return it and exchange for a different Kubota. There are some great models available, with and without the dpf filter.
4445 posts · Joined 2009. #3 · Dec 17, 2012. With the J35 flash, expect to have a regen every ~200 miles or so.. 2009 Ram 3500 4x4 Mega Laramie/Resistol DRW. FASS150, BD Intake Elbow, ARP 625 Studs + Fire Ring, Timbrens, Turbo back delete, Black Maxx w/OD, Flo-Pro, Attitude 63 Turbo, RevMax 550 Trans, Aux Trans Cooler.
I3IPF6b. 130 108 3 3 492 281 146 253 364
how long does a dpf regen take
